RGB Fish Tank, Aquarium, Fountain, Pond WATERPROOF LED Light KIT
$52.40 · In stock
Create vibrant, color-changing illumination for your aquarium without complicated wiring. This plug-and-play kit includes everything you need—just connect the LED strip and power supply to the controller, plug in, and enjoy.
Key features
Top-mount design: Place on top of the tank or under a canopy/lid (keep dry).
Not suitable for permanent submersion: Do not place the light or controller inside the aquarium.
Color & brightness control: Select any color and adjust brightness.
Preset modes: The compact controller includes pre-programmed effects—no manual programming required.
IR remote control: Manage one or multiple units with the included infrared remote (line-of-sight).
Low-voltage, plug-and-play: Simple setup for quick results.
Installation & care
Keep all components dry and outside the tank; avoid splashes and salt creep.
Provide ventilation—do not fully enclose the strip or controller.
Create a drip loop on power cords to prevent water from reaching the outlet.
If extra splash protection is needed, use a clear cover or mount under a lid with adequate airflow.
What’s in the kit
Color-changing LED strip
LED controller
Power supply
Note: Not suitable for permanent submersion or underwater use. For best performance, ensure the remote has line-of-sight to the controller.
KIT 1 — Standard Density
Waterproof IP67 Decorative RGB LED Strip (SMD 5050, 30 LEDs/m)
(splash-resistant; not suitable for permanent submersion)
RGB Controller with RF Remote (wireless control)
Power Supply — Australia approved & certified
KIT 2 — Double Density (Brighter)
Waterproof IP67 Decorative RGB LED Strip (SMD 5050, 60 LEDs/m)
(super bright; splash-resistant; not suitable for permanent submersion)
RGB Controller with RF Remote (wireless control)
Power Supply — Australia approved & certified
Important Notes
LED controller and power supply are non-waterproof — install in a dry, ventilated area.
Not recommended for outdoor or wet-area use.
Keep the light strip out of the water; for best results, mount on top of the tank or under a lid.
Add a drip loop on power cords and avoid salt creep/splashes on electronics.